Riegl Logo

Unmanned Scanning

Philipp Glira, Norbert Pfeifer, Gottfried Mandlburger: "Rigorous Strip Adjustment of UAV-based Laserscanning Data Including Time-Dependent Correction of Trajectory Errors" 20.12.2016

A new generation of laser scanners mounted on Unmanned Aerial Vehicles (UAVs) have the potential to provide highquality point clouds of comparatively small areas (a few hectares). The high maneuverability of the UAVs, a typically large field of view of the laser scanners, and a comparatively small measurement range lead to point clouds with very high point density, less occlusions, and low measurement noise. However, due to the limited payload of UAVs, lightweight navigation sensors with a moderate level of accuracy are used to estimate the platform’s trajectory. As a consequence, the georeferencing quality of the point clouds is usually sub-optimal; for this, strip adjustment can be performed. The main goal of strip adjustment is to simultaneously optimize the relative and absolute orientation of the strip-wise collected point clouds. This is done by fully re-calibrating the laser scanning system and by correcting systematic measurement errors of the trajectory. In this paper, we extend our previous work on the topic of strip adjustment by the estimation of time-dependent trajectory errors. The errors are thereby modelled by natural cubic splines with constant segment length in time domain. First results confirm the suitability of this flexible correction model by reducing the relative and absolute strip discrepancies to 1.38 cm and 1.65 cm, respectively.

Data used for this project has been acquired by RiCOPTER with RIEGL VUX-SYS including the RIEGL VUX-1UAV LiDAR Sensor mounted.

The following videos show project data acquired by the RIEGL VUX-1UAV LiDAR sensor:

VUX Pielach

VUX single tree